Monday, March 17, 2008

Types of wireless LANs

PEER TO PEER

An ad-hoc network is a network where stations communicate only peer to peer (P2P). There is no base and no one gives permission to talk. This is accomplished using the Independent Basic Service Set (IBSS).

A peer-to-peer (P2P) allows wireless devices to directly communicate with each other. Wireless devices within range of each other can discover and communicate directly without involving central access points. This method is typically used by two computers so that they can connect to each other to form a network.

If a signal strength meter is used in this situation, it may not read the strength accurately and can be misleading, because it registers the strength of the strongest signal, which may be the closest computer.

802.11 specs define the physical layer (PHY) and MAC (Media Access Control) layers. However, unlike most other IEEE specs, 802.11 includes three alternative PHY standards: diffuse infrared operating at 1 Mbit/s in; frequency-hopping spread spectrum operating at 1 Mbit/s or 2 Mbit/s; and direct-sequence spread spectrum operating at 1 Mbit/s or 2 Mbit/s. A single 802.11 MAC standard is based on CSMA/CA (Carrier Sense Multiple Access with Collision Avoidance). The 802.11 specification includes provisions designed to minimize collisions. Because two mobile units may both be in range of a common access point, but not in range of each other. The 802.11 has two basic modes of operation: Ad hoc mode enables peer-to-peer transmission between mobile units. Infrastructure mode in which mobile units communicate through an access point that serves as a bridge to a wired network infrastructure is the more common wireless LAN application the one being covered. Since wireless communication uses a more open medium for communication in comparison to wired LANs, the 802.11 designers also included a shared-key encryption mechanism, called wired equivalent privacy (WEP), or Wi-Fi Protected Access, (WPA, WPA2) to secure wireless computer networks.

Bridge

A bridge can be used to connect networks, typically of different types. A wireless Ethernet bridge allows the connection of devices on a wired Ethernet network to a wireless network. The bridge acts as the connection point to the Wireless LAN.

Wednesday, March 12, 2008

Computer networking

Network cards such as this one can transmit and receive data at high rates over various types of network cables. This card is a 'Combo' card which supports three cabling standards.
Network cards such as this one can transmit and receive data at high rates over various types of network cables. This card is a 'Combo' card which supports three cabling standards.
This article is about computer networking, the discipline of engineering computer networks. For the article on computer networks, see Computer network.

Computer networking is the engineering discipline concerned with communication between computer systems or devices. Networking, routers, routing protocols, and networking over the public Internet have their specifications defined in documents called RFCs.[1] Computer networking is sometimes considered a sub-discipline of telecommunications, computer science, information technology and/or computer engineering. Computer networks rely heavily upon the theoretical and practical application of these scientific and engineering disciplines.

A computer network is any set of computers or devices connected to each other with the ability to exchange data.[2] Examples of networks are:

* local area network (LAN), which is usually a small network constrained to a small geographic area.
* wide area network (WAN) that is usually a larger network that covers a large geographic area.
* wireless LANs and WANs (WLAN & WWAN) is the wireless equivalent of the LAN and WAN

All networks are interconnected to allow communication with a variety of different kinds of media, which including twisted-pair copper wire cable, coaxial cable, optical fiber, and various wireless technologies.[3] The devices can be separated by a few meters (e.g. via Bluetooth) or nearly unlimited distances (e.g. via the interconnections of the Internet)


History

Before the advent of computer networks that were based upon some type of telecommunications system, communication between calculation machines and early computers was performed by human users by carrying instructions between them. Many of the social behavior seen in today's Internet was demonstrably present in nineteenth-century telegraph networks, and arguably in even earlier networks using visual signals. [5]

In September 1940 George Stibitz used a teletype machine to send instructions for a problem set from his Model K at Dartmouth College in New Hampshire to his Complex Number Calculator in New York and received results back by the same means. Linking output systems like teletypes to computers was an interest at the Advanced Research Projects Agency (ARPA) when, in 1962, J.C.R. Licklider was hired and developed a working group he called the "Intergalactic Network", a precursor to the ARPANet.

In 1964, researchers at Dartmouth developed the Dartmouth Time Sharing System for distributed users of large computer systems. The same year, at MIT, a research group supported by General Electric and Bell Labs used a computer (DEC's PDP-8) to route and manage telephone connections.

Throughout the 1960s Leonard Kleinrock, Paul Baran and Donald Davies independently conceptualized and developed network systems which used datagrams or packets that could be used in a packet switched network between computer systems.

The first widely used PSTN switch that used true computer control was the Western Electric 1ESS switch, introduced in 1965.

In 1969 the University of California at Los Angeles, SRI (in Stanford), University of California at Santa Barbara, and the University of Utah were connected as the beginning of the ARPANet network using 50 kbit/s circuits. Commercial services using X.25, an alternative architecture to the TCP/IP suite, were deployed in 1972.

Computer networks, and the technologies needed to connect and communicate through and between them, continue to drive computer hardware, software, and peripherals industries. This expansion is mirrored by growth in the numbers and types of users of networks from the researcher to the home user.

Today, computer networks are the core of modern communication. For example, all modern aspects of the Public Switched Telephone Network (PSTN) are computer-controlled, and telephony increasingly runs over the Internet Protocol, although not necessarily the public Internet. The scope of communication has increased significantly in the past decade and this boom in communications would not have been possible without the progressively advancing computer network.

Network topology



The network topology defines the way in which computers, printers, and other devices are connected, physically and logically. A network topology describes the layout of the wire and devices as well as the paths used by data transmissions. Commonly used topologies include:

* Bus
* Star
* Tree (hierarchical)
* Linear
* Ring
* Mesh
o partially connected
o fully connected (sometimes known as fully redundant)

The network topologies mentioned above are only a general representation of the kinds of topologies used in computer network and are considered basic topologies.

Networking methods

Networking is a complex part of computing that makes up most of the IT Industry. Without networks, almost all communication in the world would cease to happen. It is because of networking that telephones, televisions, the internet, etc. work.

One way to categorize computer networks is by their geographic scope, although many real-world networks interconnect Local Area Networks (LAN) via Wide Area Networks (WAN). These two (broad) types are:

Local area network (LAN)

A local area network is a network that spans a relatively small space and provides services to a small number of people. Depending on the number of people that use a Local Area Network, a peer-to-peer or client-server method of networking may be used. A peer-to-peer network is where each client shares their resources with other workstations in the network. Examples of peer-to-peer networks are: Small office networks where resource use is minimal and a home network. A client-server network is where every client is connected to the server and each other. Client-server networks use servers in different capacities. These can be classified into two types: Single-service servers, where the server performs one task such as file server, print server, etc.; while other servers can not only perform in the capacity of file servers and print servers, but they also conduct calculations and use these to provide information to clients (Web/Intranet Server). Computers are linked via Ethernet Cable, can be joined either directly (one computer to another), or via a network hub that allows multiple connections.

Historically, LANs have featured much higher speeds than WANs. This is not necessarily the case when the WAN technology appears as Metro Ethernet, implemented over optical transmission systems.


Wide area network (WAN)

A wide area network is a network where a wide variety of resources are deployed across a large domestic area or internationally. An example of this is a multinational business that uses a WAN to interconnect their offices in different countries. The largest and best example of a WAN is the Internet, which is a network comprised of many smaller networks. The Internet is considered the largest network in the world.[6]. The PSTN (Public Switched Telephone Network) also is an extremely large network that is converging to use Internet technologies, although not necessarily through the public Internet.

A Wide Area Network involves communication through the use of a wide range of different technologies. These technologies include Point-to-Point WANs such as Point-to-Point Protocol (PPP) and High-Level Data Link Control (HDLC), Frame Relay, ATM (Asynchronous Transfer Mode) and Sonet (Synchronous Optical Network). The difference between the WAN technologies is based on the switching capabilities they perform and the speed at which sending and receiving bits of information (data) occur.

For more information on WANs, see Frame Relay, ATM and Sonet.


Wireless networks (WLAN, WWAN)


A wireless network is basically the same as a LAN or a WAN but there are no wires between hosts and servers. The data is transferred over sets of radio transceivers. These types of networks are beneficial when it is too costly or inconvenient to run the necessary cables. For more information, see Wireless LAN and Wireless wide area network. The media access protocols for LANs come from the IEEE.

The most common IEEE 802.11 WLANs cover, depending on antennas, ranges from hundreds of meters to low kilometers. For larger areas, either communications satellites of various types, cellular radio, or wireless local loop (IEEE 802.16) all have advantages and disadvantages. Depending on the type of mobility needed, the relevant standards may come from the IETF or the ITU.